Connection to our wireless probes
Adquio LoRa sensors gateway
With this device, the Adquio Ecosystem integrates all wireless probes, and does so with the latest technology. On the one hand, Adquio LoRa Sensors Gateway connects to any programmable controller that supports the Modbus RTU protocol and on the other hand to our wireless probes.
Each ‘Adquio LORA Sensors Gateway’ can receive up to 30 temperature, humidity, CO2 and particle probes.
LoRa communication technology allows you to place our probes throughout a building almost without worrying about whether their signal will reach the receiver. They have a very long range and high penetration in walls and floors, so the fact of being in a different room or even on a different floor will not be a problem to receive the data correctly.
SPECIFICATIONS
Adquio LoRa sensors gateway
Front end data and bottom connectors
- Power-on confirmation LED.
- Online LED, the device is connected and sending data to a master.
- Error LED.
- 485 Modbus RTU connector, contacts A,B,GND (from left to right).
- Microswitches for Modbus address selection.
- Power connector, + and – (from left to right), 24 volts DC.
Top connectors
- Outdoor LoRa Antenna Connector. 433/863/915 Mhz omnidirectional antenna that can be repositioned with an adapter cable.
Technical specs
Connectivity
Protocol:
Modbus RTU
Communication speed and parameters.
From 9,600 to 57,600 Bps configurable by Modbus (Reset required to apply).
Energy
Power supply
8 – 24Volts direct current, typical 24V.
Consumption
20mA
Wireless connectivity
Technology
LoRa
Frequency
433/863/915 Mhz
Coverage
100M indoors.
Capacity
Maximum number of wirelessly connected devices
Up to 30 probes per gateway
Mounting
Anchoring system
DIN rail or flat surface with 2 screws.
Certificaciones
Safety and Health
EN ISO 13849-1: 2015
EN ISO 13849-2: 2012
EN 62061:2005 + A1:2013 + A2:2015
EN 60950-1:2006
EN 62311:2008
EMC
EN 61000-6-4:2007 + A1:2011
EN 61000-6-2:2005
RoHS
EN 50581:2012
