Adquio Multi Sensors is a compact device that integrates temperature, humidity, Co2 and particle probes. It is connected via Modbus RTU and is powered between 12 and 24V. Its main features are: small size and reliability. Up to 64 probes can be configured on the same bus. By default, they are set to 9600 Baud N81, but you can change any of the parameters via Modbus.

All sensors will be calibrated and can be adjusted independently by software.

They are fixed to the wall with 3M double-sided or with screws (not supplied).

Adquio Multi Sensors has duplicate wiring connections. This allows for easy bus installation, as you can use one set of connectors as an input, and the other as an output to the next device.

Additionally, the connectors are pressure connectors, you only have to press with the tip of a screwdriver the button that has each terminal, and the cable or tip will enter easily, when you release it will be firmly connected.

These are the values of the connectors:

1. Positive terminal power supply from 12 to 24v direct current.
2. Negative power supply terminal.
3. Pole A or positive of the 485 communication bus.
4. Pole B or negative of the communication bus 485.
5. Micro-switch block to configure the modbus address of the device.

In the attached table you can see the Modbus registers configuration, also available in the product datasheet that you can download below.