More control channels in your panel
Add eight analogue outputs when your controller needs to regulate more equipment. Send setpoints to the module via Modbus RTU and use them in your automation logic.
Expansions and modules
Add eight analogue outputs to send setpoints and commands to compatible equipment. Configure operation through Modbus RTU and the module’s supported ranges.

EXPAND YOUR ANALOGUE CONTROL
Adquio 8 Analog Outputs adds eight 0–10 V outputs to an Adquio controller or another compatible Modbus RTU master. Regulate fans, valves, dampers and other equipment designed to receive this signal.
Expand the outputs in your panel or install the module close to the equipment, connected to the controller via RS-485.

Add eight analogue outputs when your controller needs to regulate more equipment. Send setpoints to the module via Modbus RTU and use them in your automation logic.
Locate the control outputs where they are needed and maintain RS-485 communication with the controller. The 0–10 V signal sets the equipment’s setpoint; its power supply is sized separately.
The controller calculates the setpoint and sends it via Modbus RTU. The module then generates the 0–10 V signal for the equipment.
Set the operating setpoints from your control interface. For example, Adquio SCADA Server.
Logic and commands are sent to the module via Modbus RTU. Example: Adquio Mini.

Generates eight 0–10 V signals from the received setpoints.
Fans, valves, dampers and other actuators compatible with a 0–10 V setpoint.


| Nominal voltage | 24 V DC |
|---|---|
| Consumption | 15 mA |
| Maximum consumption | 20 mA |
| Maximum supported voltage | 28 V DC |
| Port | 1 · RS-485 protected slave |
|---|---|
| Protocol | Modbus RTU |
| Communication speed | 9600 / 19200 bps |
| Modbus address | Microswitches |
| Number of outputs | 8 |
|---|---|
| Range | 0–10 V DC |
| Resolution | 12 bits |
| Signal reference | 2 · GND |
| Status LEDs | 2 · Power, Online |
|---|
| Mounting | Horizontal · 35 mm DIN rail |
|---|---|
| Protection rating | IP20 |
| Housing | ABS UL-94-HB |
| Operating temperature | 0–60 °C |
|---|---|
| Storage and transport | −40–70 °C |
| Maximum relative humidity | 95% · non-condensing |
| Safety and Health | EN ISO 13849-1: 2015 EN ISO 13849-2: 2012 EN 62061: 2005 + A1: 2013 + A2: 2015 EN 60950-1: 2006 EN 62311: 2008 |
|---|---|
| EMC | EN 61000-6-4: 2007 + A1: 2011 EN 61000-6-2: 2005 ETSI EN 301 489-1 v2.2.0 ETSI EN 301 489-17 v3.2.0 |
| RoHS | EN 50581:2012 |
Plan your integration with our engineering team and find the right solution for your installation.